Hanwell CR3 Controller Base Station

Hanwell CR3 base station with receiver, retrieves and processes signals from *Hanwell Pro radio sensors. These sensors communicate at regular short intervals with the CR3, which logs and stores the data pending transfer to a PC for analysis and archival storage.  Also consider the Hanwell SR2 Smart Receiver, more commonly installed by Fluidic for typical, industrial type networked application.

All data from the sensors is collected, processed and stored in the Hanwell CR3.  Transfer to the computer is automatic when the computer is running. When the computer is off-line the CR3 will back up data internally until the computer comes back on line where the automatic data transfer will recommence. The Hanwell CR3 is normally located near the computer that is being used to monitor the data. An on-board 16 x 2 alpha-numeric LCD displays the system status. The Hanwell CR3 also signals alarm conditions via the front panel LED’s (should any sensor measure above or below individual pre-set levels). Hanwell CR3 has an on-board relay that can be configured to drive external alarm devices where required.

Hanell CR3 Options

• Built in GSM module for remote communications via the mobile phone network
• RS485 output* to drive Hanwell Pro MS1000 control cards for building control or data replication
• Modbus RTU Expansion* for interfacing to third party systems and BMS systems

Typical Applications

• Warehouse/Storage monitoring
• Interface to BMS systems
• Remote monitoring where there are no computers or networks GSM, RS485 and Modbus are factory fitted options

Hanwell EMS Environmental Monitoring Software

Fluidic are a recognised partner of Hanwell (Industrial division) for Scotland and the North of England. Our instrumentation engineers are product trained and able to help with instrument selection within the full Hanwell wireless system. Please call either office for more information (Glasgow 0141 641 5920, Warrington 01925 572401).